Moog Werkstatt Synth Kit

OSCILLATOR SECTION • Single VCO w/ frequency control (8Hz to 16KHz) • Saw and square waveshapes w/ control for square pulse width • Envelope or LFO selectable Mod Source that can be assigned to PWM or Pitch w/ Amount control • Ability to PWM the square wave FILTER SECTION • Classic 4-Pole Moog Ladder Filter w/ Resonance control (20Hz-20KHz) • Select between the Envelope generator and LFO as Mod Source. • Polarity switch (+/-) and amount knob for control of filter cutoff modulation LFO SECTION • Selectable Square or Triangle waveshape w/ rate control (2Hz-600Hz) VCA/AMP SECTION • Select between the Envelope Generator or ON (Drone) ENVELOPES SECTION • Controls for Attack & Decay time w/ Sustain On/Off switch KB SECTION • One octave low-note priority legato keyboard w/ glide control PATCHBAY • VCA Input 0V to +5V in VCA EG Mode, +/-2.5V in VCA ON Mode • VCF Input -5V to +5 • VCO LINEAR FM Input +/-2.5V - NOTE: this is an inverting control input • VCO EXPONENTIAL FM Input -5V to +5V, 1V/Octave trimmable • LFO CV Input 5V to +5V – NOTE: Negative CV slows LFO more than the panel • VCF AUDIO InputUnbuffered/Unmixed AC coupled input to VCF • 2x KB CV Output3V/semitone from 1 keyboard - NOTE: Attenuate for 1V/Octave • 2x TRIG Output 5 msec pulse, 0 to +5 V signal generated from low-note priority • 2x GATE Output0 to +5V signal generated from low-note priority • 2x EG Output0 to +5V signal, Simple ASD or AD type Envelope Generator • 2x LFO Output -2.5 to +2.5V Triangle or Square wave, selected via LFO Switch • 2x VCF Output-2V to +2 V signal for audio or CV uses • 2x VCO Output0V to +5V VCO signal, wave selected by VCO Wave Switch Rear Panel • AUDIO Output Nominal +/-1.5V Signal • POWER+12VDC Center Positive w/ 1.2A Wall transformer • POWER CONSUMPTION 1.8 Watt AVG